- Disassembly Overview
- Electrostatic Discharge (ESD)
- EMI (Electromagnetic Interference)
- Disassembly
- Tools
- Opening the Case
- Cables and Connectors
- Storage Devices
- Motherboards
- Mobile Device Issues
- Reassembly
- Preventive Maintenance
- Basic Electronics Overview
- Electronics Terms
- Power Supply Overview
- Power Supply Form Factors
- Purposes of a Power Supply
- Power Supply Voltages
- Mobile Device Travel and Storage
- Mobile Device Power
- ACPI (Advanced Configuration and Power Interface)
- Replacing or Upgrading a Power Supply
- Symptoms of Power Supply Problems
- Solving Power Supply Problems
- Adverse Power Conditions
- Adverse Power Protection
- Surge Protectors
- Line Conditioners
- Uninterruptible Power Supply (UPS)
- Standby Power Supply (SPS)
- Phone Line Isolator
- Electrical Fires
- Computer Disposal/Recycling
- Soft Skills?Written Communications Skills
- Chapter Summary
- Key Terms
- Review Questions
- Exercises
- Activities
Motherboards
Chapter 2 covered motherboard replacement extensively, and here we discuss issues related to building a computer from scratch or disassembling a computer: I/O shield, standoffs, and retaining clips. Some cases include a standard I/O panel shield that may need to be removed to install the I/O shield that comes with some motherboards. The I/O shield is a part what allows for optimum air flow and grounding for the motherboard ports. The I/O shield helps ensure the motherboard is installed correctly and properly aligned with the case. Figure 4.11 shows a motherboard I/O shield.
Figure 4.11. Motherboard I/O shield
Some computer cases have plastic or metal (commonly brass) standoffs that allow the motherboard to be screwed into the case without the motherboard solder joints touching and grounding to the computer case, causing the motherboard not to work. Some standoffs are plastic, and they slide into slots on the computer case. Do not remove these types of standoffs but just leave them attached and slide the motherboard out of the slots. The most common type of standoff is a metal standoff that screws into the case; this standoff has a threaded side that the motherboard sits on and a screw that attaches the motherboard to the standoff, as shown in Figure 4.12.
Figure 4.12. Motherboard standoff
Some motherboards not only have screws that attach them to the metal standoffs but one or more retaining clips. A retaining clip might need to be pressed down, lifted up, or bent upward in order to slide the motherboard out of the case. The case might contain one or more notches and require the motherboard to be slid in a particular direction (usually in the direction going away from the back I/O ports) before being lifted from the case.